Combi Flash EX 655 Especificações descarregar pdf (Página 29)

Translation of the original operation manual 29

MDFE_mAtex_1307_en • jw

Start-up and operation

5.4 Change of material

The entire system has to be flushed thoroughly to avoid any possible che-

mical reaction with the new coatings material.

1. Shutting down

Follow all the instructions found in chap. 5.5 Shutting down on page 29.

2. Shutting down the equipment

After disconnecting the heater from the electrical power supply, perform

all steps covering changing materials and/or shutting down as found in the

Operation manual for the spray pump/system.

3. Flush

Flush the complete system:

– when the unit is cold

– disconnected from the electrical power supply

Use the solvent that is recommended by the coatings manufacturer.

Follow the instructions found in the operation manual of your spraying

equipment covering changing materials and/or starting up the unit.

4. Restarting the unit

Follow the instructions found in the Operation manual for the spraying

equipment being used.

Complete the instructions found in see chap. „5 Start-up and operation“,

P. 27, Step 4-6.

5.5 Shutting down

1. Turn off the Fluid Heater

– Turn off the Fluid Heater 10 minutes before

work is completed.

– To do this, turn the temperature knob to the

position „I“ Pic. 6.1.

– This will enable the operator to use the residual

heat up until the end of work while shortening

the cooling time until the unit can be flushed.

Pic. 6.1

2. Disconnect from electrical power supply

Disconnect the heater from the electrical power supply.

3. Flush

Avoid damage to the unit and the entire system by thoroughly flushing after

every shutdown.

approx.

2 minutes



1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

Sem comentários

Combi Flash EX 655 Especificações Página 29