Combi 7720 Manual de Instruções

SPERIANSURVIVAIR Opti-Fit™S-SeriesFull Facepiece Air Purifying RespiratorOperation and Maintenance ManualWARNINGDO NOT USE this respirator until you c

101051 Combination Organic Vapors and P1001052 Combination Acid Gases and P1001053 Combination Organic Vapors, Acid Gases, and P1001054 Combination Am

11Acroline Carbonyls Hydrogen Selenide OzoneAniline Cyanogen Methanol PhosgeneArsine Dimethylaniline PhosphineBoron Hydrides Dimethyl Sulfate Methylen

12WARNINGFilters improperly used or improperly assembled to the facepiece could cause leakage, which could lead to personal injury, illness, or dea

13NOTEWhen properly adjusted, the headstrap hub should be centered on the back of your head, and the lower straps should be below your ears.OPTI-FIT F

14VIII. HOW TO USE THE RESPIRATORTo receive the maximum protection available from your respirator, you must read, understand, and follow all the Warni

15replaced whenever they are damaged, soiled, contaminated with water, or as soon as they are too difcult to breathe through. Sperian recommends, due

16CAUTIONDo not use solvent type cleaners to clean any part of the respirator.NOTESilicone and rubber parts of the facepiece may be cleaned between wa

17WARNING• The failure to comply with this warning may lead to personal injury, ill-ness, or death.XIV. REPAIR (See the Repair Table)Repair by the use

18XVIII. ADDITIONAL INFORMATIONIf you need assistance or additional information on any SPERIAN product, consult your local distributor or contact:SPER

19XX. INSPECTION TABLEIF ANY OF THE DEFECTS LISTED ARE FOUND, HAVE THE RESPIRATOR REPAIRED BEFORE USE.COMPONENT LOOK FORFACEPIECE LENS 1. Nicks, scr

2Table of ContentsNIOSH CAUTIONS AND LIMITATIONS ... 3I. INTRODUCTION... 3II. SAFETY PRECA

20XXI. REPAIR TABLECOMPONENT INSTRUCTIONSHEADSTRAP REPLACE-MENT1. Remove the old headstrap from the facepiece, noting the routing of the straps.2. Ins

21XXI. REPAIR TABLE (Continued)COMPONENT INSTRUCTIONSLENS REPLACEMENT 1. Remove any cartridges and/or lters from the con-nectors.2. Use a 5/32 inch A

22www.sperianprotection.com

3NIOSH APPROVAL CAUTIONS AND LIMITIONSA - Not for use in atmospheres containing less than 19.5 percent oxygen.B - Not for use in atmospheres immediate

4NOTEMaintenance or operating procedures and techniques or information consid-ered important enough to emphasize.III. DESCRIPTIONThe SURVIVAIR Opti-Fi

5WARNING—Continued• Do not use this respirator at ambient temperatures above 130°F (55°C).• Do not use this respirator where environmental conditions

6WARNING—Continuedsensitizers. Use positive pressure supplied air respirators to provide better protection from these chemicals. Do not use

7IV. PARTS LIST (See Figure 1)ITEM QTY P/N DESCRIPTION1a 1 702009 Headstrap, TPE1b 1 702089 Headnet, Mesh, Opti-Fit2 1 962157 Small Skirt, Silicone1 9

8Note: Quantities in parentheses are for headnet conguration only.Optional Accessories702019 Peel-away Lens Cover, Tinted (25)702028 Peel-away Lens C

9Table 1. Cartridges and Filters (S-Series)(See NIOSH Approval Label for Specific Contaminants)MODEL FILTERS1050 P1001060 Filter Pad, N951070 Filter P